MFlenses - Új élet a digitális korban
MFLenses 2026

Manuális fókuszú objektívek fóruma

Fedezd fel a régi objektívek világát javítási jegyzetekkel, valódi tesztképekkel és képekkel teli archív témákkal.

Fedezd fel a régi objektívek világát javítási jegyzetekkel, valódi tesztképekkel és képekkel teli archív témákkal.
Reflektorfény

Kiemelt partneri hely a fórum nyitólapján.

distance to focused object
Előző téma megtekintése :: Következő téma megtekintése  


Reply

Hi
We know canon get subject distance from lenses for E-TTL II Flash systems

Idézet:
The main improvement of E-TTL II is that it gives a more natural flash exposure, by being able to handle tricky scenes where normally the old E-TTL system will be thrown off. Such improvements are possible because E-TTL II now incorporates lens-to-subject distance information in its calculation (where available) to assist in determining an approximate guide number for flash output. The flash metering system is also no longer linked to the AF system, where in the old E-TTL metering bias is given to the selected AF point. Rather, E-TTL II compares the ambient and the pre-flash light levels of the scene to determine where the subject lies. This gives the photographer flexibility to lock focus and recompose the scene without fooling the flash metering system. 'Hotspots' (areas of high reflectance) that will normally throw off the flash metering system are also ignored in the calculation.



I need get focus distance (distance to focused object) from canon EF lense.

How can i get it from the eos mount pins?
or
Are you know about AF chip that attached to eos mounts and can get focus distance (or any focus position number) by it.

very thanks


Reply

Welcome!

Nice to see you here !


Reply

Welcome!
I have never trusted ETTL or ETTL 2 as it seems to NEVER get the light right. I have a small laminated card with exposure calculations on it for my 430EX. EX: f/8 @ ISO 100= 6ft (not a real calculation just example)

I find this cheat sheet to be much better than ETTL or ETTL 2. Just judge the distance and set your flash accordingly. It's the reason old flashes had this info printed on them- it's very reliable.