MFlenses - Új élet a digitális korban
MFLenses 2026

Manuális fókuszú objektívek fóruma

Fedezd fel a régi objektívek világát javítási jegyzetekkel, valódi tesztképekkel és képekkel teli archív témákkal.

Fedezd fel a régi objektívek világát javítási jegyzetekkel, valódi tesztképekkel és képekkel teli archív témákkal.
Reflektorfény

Kiemelt partneri hely a fórum nyitólapján.

Small screw supplier
Előző téma megtekintése :: Következő téma megtekintése  


Reply

I don't know if some of these would be the correct size for lenses or not.
Has anyone seen this yet?

http://stores.ebay.com/LaptopScrews/_i.html?LH_SellerWithStore=1&LH_TitleDesc=1&_armrs=1&_from=&_ipg=&_sasi=1


Reply

walter g írta:
I don't know if some of these would be the correct size for lenses or not.
Has anyone seen this yet?

http://stores.ebay.com/LaptopScrews/_i.html?LH_SellerWithStore=1&LH_TitleDesc=1&_armrs=1&_from=&_ipg=&_sasi=1


Interesting thanks. I think most lenms screws are less than 2mm diameter. I see they have some M1.6.

I bought a jewellers thread plate with all sizes from 0.7mm to 2mm, along with a set of taps which ought to be able to cut all common threads for lenses (I hope). I have yet to try it out though Smile


Reply

martyn_bannister írta:
walter g írta:
I don't know if some of these would be the correct size for lenses or not.
Has anyone seen this yet?

http://stores.ebay.com/LaptopScrews/_i.html?LH_SellerWithStore=1&LH_TitleDesc=1&_armrs=1&_from=&_ipg=&_sasi=1


Interesting thanks. I think most lenms screws are less than 2mm diameter. I see they have some M1.6.

I bought a jewellers thread plate with all sizes from 0.7mm to 2mm, along with a set of taps which ought to be able to cut all common threads for lenses (I hope). I have yet to try it out though Smile



If you don't mind me asking, where did you get it from?


Reply

walter g írta:
martyn_bannister írta:
walter g írta:
I don't know if some of these would be the correct size for lenses or not.
Has anyone seen this yet?

http://stores.ebay.com/LaptopScrews/_i.html?LH_SellerWithStore=1&LH_TitleDesc=1&_armrs=1&_from=&_ipg=&_sasi=1


Interesting thanks. I think most lenms screws are less than 2mm diameter. I see they have some M1.6.

I bought a jewellers thread plate with all sizes from 0.7mm to 2mm, along with a set of taps which ought to be able to cut all common threads for lenses (I hope). I have yet to try it out though Smile



If you don't mind me asking, where did you get it from?


I purchased mine HERE, but they are available from several suppliers. As I say, I am hoping that these are the right sizes for lens screws, but my household is in a huge upheaval at the moment and I haven't had a chance to try them out Smile I also bought a quantity of piano wire off ebay to make screws from. The standard wire gauges are only a few 1/100 mm off each even numbered size.