MFlenses - Új élet a digitális korban
MFLenses 2026

Manuális fókuszú objektívek fóruma

Fedezd fel a régi objektívek világát javítási jegyzetekkel, valódi tesztképekkel és képekkel teli archív témákkal.

Fedezd fel a régi objektívek világát javítási jegyzetekkel, valódi tesztképekkel és képekkel teli archív témákkal.
Reflektorfény

Kiemelt partneri hely a fórum nyitólapján.

Hole dimension for 1/4" thread?
Előző téma megtekintése :: Következő téma megtekintése  


Reply

Anybody knows the hole (drill dimension, pls. in mm) I need when I want to tap a 1/4" VNC (tripod socket) thread into it?


Reply

5.1mm to be exact, but 5mm is fine.

The thread is 1/4 Whitworth or 1/4 UNC ( not VNC ) The difference between Whitworth and UNC is so small that it makes no difference, but UNC taps are probably easier to get.


Reply

I'm pretty sure my Zeus book says 5.2mm for 1/4 UNC. But I'm about 900 miles away from it at the moment so I can't check. I don't have Whitworth taps, so I've always used 1/4 UNC without problems. As Lloydy says, there is almost no difference in the thread.


Reply

You have access to HIM, the great god of lenses - ZEUSS himself??? Laughing


Reply

5.1 for Whit' and 5.2 for UNC. Or 5mm will do. Wink