MFlenses - Új élet a digitális korban
MFLenses 2026

Manuális fókuszú objektívek fóruma

Fedezd fel a régi objektívek világát javítási jegyzetekkel, valódi tesztképekkel és képekkel teli archív témákkal.

Fedezd fel a régi objektívek világát javítási jegyzetekkel, valódi tesztképekkel és képekkel teli archív témákkal.
Reflektorfény

Kiemelt partneri hely a fórum nyitólapján.

Loose lens mount
Előző téma megtekintése :: Következő téma megtekintése  


Reply

My Canon T70 has a body mount that is a tad loose. Can see no way of tightening it up. Am thinking of a SLIGHT touch of super glue. Comments?


Reply

Have you taken the shroud off as there could be some screws underneath.


Reply

oh do go oooooon. Razz


Reply

It might have been a T70 I fixed (so many cameras Wink )...looking at my T70 there are two screws Question holding the plastic molding around the mount in place, unscrew them and the molding comes off and then you can tighten the mount screws.


Reply

Can only see 4 screws holding the external mirror box on but taking them off doesnt free anything, so have no idea how to take the metal (chrome) lens mount off


Reply

erm something must be holding the lens mount in place and it's usually screws


Reply

Nope, cannot find any screws on the lens mount itself nor any holes where screws might have been. Used superglue instead


Reply

Apparently its help it place by 4 screws INSIDE, how to get at 'em is a mystery


Reply

trev írta:
Apparently its help it place by 4 screws INSIDE, how to get at 'em is a mystery


Indeed as I've found my service manual.....crappy sketches and not clear English, but it looks like the front cowling comes off by setting the shutter lock button to "L" (huh they probably mean put it in the lock position) and LOOSEN the two screws in the base plate, well I can see three Question maybe they mean just the one under the cowling (and h'mm it doesn't mention the top front one and two around the side Question ) ........and when the screws (or screw) in the base are loosened, it probably gives a bit of slack, then pinch the four corners of the cowling and it would lift off.


A hozzászólás legutóbb Excalibur által Pént. Máj. 09, 2014 7:43 pm-kor lett szerkesztve, összesen 8 alkalommal.


Reply

Plastic cover is held by few screws - watch closely (front and both sides including lever to open film compartment if I remember correctly). If you will not find them then I can take photos and show you. All in all easy task - about 15 min with brake for coffe Wink.