MFlenses - Új élet a digitális korban
MFLenses 2026

Manuális fókuszú objektívek fóruma

Fedezd fel a régi objektívek világát javítási jegyzetekkel, valódi tesztképekkel és képekkel teli archív témákkal.

Fedezd fel a régi objektívek világát javítási jegyzetekkel, valódi tesztképekkel és képekkel teli archív témákkal.
Reflektorfény

Kiemelt partneri hely a fórum nyitólapján.

rangefinder spring issue on Fed 5B
Előző téma megtekintése :: Következő téma megtekintése  


Reply

hey people!
following this article (http://jay.fedka.com/index_files/Page422.htm)i started to adjust the rangefinder on my Fed 5, since it was completely off.


i succeeded to adjusted the vertical axis and after setting the infinity focus i found an issue for the close focussing.

the close focus adjustment is done by twisting the notch on the arm that moves the rangefinder, see below:



now i found out that the arm doesn't get pulled sufficiently upwards to reach the minimum focus distance.
it is controlled by a spring, and only but fully pushing the arm downwards and letting it go it pops back into it furthest position.
when the lens moves from infinity to minimum the spring pressure is not strong enough the move the arm to it's furthest position.


any people experience with this issue? any ideas how to fix this spring?


Reply

You probably figured this out by now, but for the benefit of anybody else - the rangefinder arm doesn't approach anything near the full forward position when a lens is mounted - so there is no issue. And if you've already checked this with a lens mounted, then I'm not sure there is much to do for it other than maybe to put a spot of oil on the arm bushing and hope it frees up some. I have had a camera where this bushing was seized up and the only possible repair would have meant replacing the arm itself.